HP M3035 - LaserJet MFP B/W Laser - Page 181

2. Remove the cables from the cable guide (callout 1) and then remove two screws (callout 2) from
the tray 2 solenoid plate. Press the tab on the pickup shaft gear (callout 3) and then slide the gear
off of the shaft.
NOTE Keep the parts of the pickup-shaft gear together to make sure that the small spring
inside remains with the gear.
1
2
3
Figure 5-86 Removing the pickup assembly (1 of 4)
ENWW Pickup assembly 169