Pickup assembly
1. Remove the following components:
●
All of the covers (see
Covers on page 94) and the ADF/scanner assembly (see Scanner
assembly on page 90)
●
Disk drive (see
Disk drive on page 113)
●
Formatter (see
Formatter on page 116)
●
Stapler (see
Stapler on page 117) and stapler power-supply (see Stapler power-supply
on page 123)
●
ECU (see
Engine control unit (ECU) on page 131)
●
Left-side riser (see
Left-side riser on page 138)
●
Access plate (see
Access plate on page 144)
●
Fuser (see
Fuser on page 139)
●
Oblique-roller assembly (see
Oblique-roller assembly on page 146).
●
Left-side fan (see
Left-side fan on page 148)
Tip You do not have to unroute the left-side-fan cable in order to remove the HVPS,
the feed-guide assembly, the gear assembly, or the pickup assembly. After removing
the fan from its hole in the chassis, simply set the fan down on the workspace.
●
High-voltage power supply (see
High-voltage power supply (HVPS) on page 149)
●
Feed-guide assembly (see
Feed-guide assembly on page 156)
●
Gear assembly (see
Gear assembly on page 162)
168 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...