HP M3035 - LaserJet MFP B/W Laser - Page 179

Tray 2 solenoid
1. Remove the following components:
●
All covers (see
Covers on page 94) and the ADF/scanner assembly (see Scanner
assembly on page 90)
●
Fax accessory (see
Fax accessory on page 111)
●
Disk drive (see
Disk drive on page 113)
●
Formatter (see
Formatter on page 116)
●
Stapler (see
Stapler on page 117) and stapler power-supply (see Stapler power-supply
on page 123)
●
Right-side fan (see
Right-side fan on page 128)
●
ECU (see
Engine control unit (ECU) on page 131)
●
High-voltage power supply (see
High-voltage power supply (HVPS) on page 149)
●
Gear assembly (see
Gear assembly on page 162)
2. Remove one screw (callout 1).
1
Figure 5-85 Removing the tray 2 solenoid
3. Lift the solenoid off of the device chassis.
ENWW Tray 2 solenoid 167