6. Use a short screwdriver to remove two screws (callout 7) and then remove the remaining two
screws (callout 8) from the pickup assembly.
8
7
Figure 5-89 Removing the pickup assembly (4 of 4)
7. Lift the assembly out of the device starting at the opposite end from the gear-end of the assembly.
NOTE After removing the pickup assembly, the top-of-page sensor is easily accessible.
To remove the top-of-page sensor, use a short screwdriver to remove two screws from the
sensor cover, remove one screw from the sensor, unthread the sensor cable, and then lift
the sensor out of the device.
172 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...