Tray 1 media-present sensor and top-of-page sensor
The tray 1 media-present sensor is exposed when the roller-stay assembly is removed in step 5 of the
pickup assembly removal (see
Pickup assembly on page 168). To remove the sensor, remove one screw
(callout 1), unthread the sensor cable, and then lift the sensor out of the device.
To remove the top-of-page sensor, remove the pickup assembly (see
Pickup assembly on page 168
and then remove two screws (callout 2) from the sensor cover. Lift the sensor cover out of the device
to expose the top-of-page sensor, and then remove one screw from the sensor.
2
1
Figure 5-90 Removing the tray 1 media-present sensor and the top-of-page sensor
ENWW Tray 1 media-present sensor and top-of-page sensor 173
To Next Page
Loading...