Interface troubleshooting
Communications checks
NOTE Communication problems are normally the customer's responsibility. Time spent
attempting to resolve these problems might not be covered by the Hewlett-Packard product
warranty. Refer the customer to the network administrator for assistance in troubleshooting
network problems.
LAN hardware test
1. To perform a LAN hardware test, touch Administration.
2. Touch Initial Setup.
3. Touch Networking and I/O.
4. Touch Embedded Jetdirect.
5. Touch Diagnostics.
6. Touch LAN HW Test.
7. Touch Yes to run the test.
If the test fails, replace the formatter (see
Formatter on page 116).
NOTE For a complete list of Jetdirect menus, see the user guide.
ENWW Interface troubleshooting 225
To Next Page
Loading...