To Next Page

To Previous Page

2. Temporarily take out the metal ring and put the Anti-slippery Sticker on the gutter of the

camera. Then, peel off the transparent film. Put on metal ring once again.

3. Insert A of the Mount in the middle of metal ring, and confirm the white mark on camera is

always positioned up. This is to make sure the capture image is in correct angle. Use screw

driver to fix to the Mount.

4. Take out the rear-view-mirror from the motorcycle. Insert B of the Mount into the bar of

rear-view-mirror.

Questions and Answers:

Need help?

Do you have a question about the HP m500 and is the answer not in the manual?

HP m500 Specifications

General