HP ML310 - ProLiant - G2 - Non-Hot-Plug SCSI Hard Drive

46 HP ProLiant ML310 Generation 2 Server User Guide
2. Install the drive cage into the chassis, and secure with the six (6) Torx
screws.
3. Connect the data and power cables to the rear of the installed hard drive.
Non-Hot-Plug SCSI Hard Drive
To remove the component:
1. Power down the server.
2. Remove the access panel ("Removing the Access Panel" on page 22
).
3. Disconnect the power and data cables from the rear of the hard drive.