Removal and Replacement Procedures
3. Disconnect all external peripheral devices from the server.
4. Remove the cable management arm from the server.
Figure 2-7: Disconnecting all cables from the server
Figure 2-8: Removing the cable management arm from the server
NOTE: You may leave the cables attached to the cable management arm.
5. Loosen the thumbscrews that secure the front bezel to the front of the rack.
6. Slide the server out of the rack.
7. Place the server on a sturdy, level surface.
2-10 HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
To Next Page
Loading...
