MSM3xx / MSM4xx Access Points 5.3.5 Release Notes 4 HP ProCurve Networking
46012 The CLI command show dot11 statistics client-traffic does not display the correct
information for 802.11 rates.
46019 An internal problem is causing messages similar to the following to appear in the log:
assert: retry.c IsTimeToRetry 52 (aRetryInfo->mRetryType ==
RETRY_TYPE_CONSTANT && aRetryInfo->mRetry.mInterval
46293 The ETSI DFS channels for EU countries are not permitted and have been removed for
all revision B products with CM9 radio. See also the MSM Access Point Quickstarts.
46383 (MSM317 only.) In some cases the MSM317 may frequently lose connectivity with the
controller and fail to report statistics properly.
46512 The SNMP object “coDot11PktsRate54” shows only receive rates. Transmit rates are
missing.
46554 In some cases, 802.1X authentication may not work properly.
47634 (MSM410 only.) The MSM410 may stop advertising SSIDs with the following message
added to the system log:
ar5416GetPendingInterrupts: received PCI FATAL interrupt
47773 (MSM317 only.) The MSM317 restarts when trying to retrieve debugging information on
the Controlled APs > [AP] >> Tools > Debugging tools page.
47831 The antenna icons (which indicate the mode of operation for an AP) on the Controlled
APs >> Overview > Discovered APs page may intermittently disappear when the AP
is handling a large amount of wireless traffic.
47916 Under certain conditions, performance may be dramatically reduced for long periods of
time when clients use 802.11 power save mode.
47980 (MSM317 only.) If a switch port is configured with a VLAN, after a few days the VLAN is
lost and traffic gets sent untagged.
48057 (MSM317 only.) When the MSM317 is configured to support six or more VSCs, wireless
clients may be unable to connect to some of the VSCs.
48594 When fragmentation was required on a tunnel interface due to the MTU size limitation of
a tunnel, a “UDP loop detected” error was incorrectly being sent to the syslog.
48666 If you define a custom wireless security filter using the %g placeholder, it will not work
because the %g placeholder is not interpreted correctly by the AP.
50105 (MSM317 only.) If an MSM317 switch port has MAC authentication enabled, or is bound
to a VSC with MAC authentication enabled, after a few days, client stations are unable
to authenticate through the port.
50485 When handling a large amount of wireless traffic, an AP may lose its IP address and be
unable to get a new one from a DHCP server.
50806 Changing the time zone to GMT +8 on a controller results in APs not being able to
synchronize.
51473 (MSM317 only.) If the MSM317 Uplink port is connected to a network with a high traffic
load, the MSM317 may lose synchronization with the controller.
51940 Broadcast packets to or from a roaming client are sometimes dropped.
ID Description
To Next Page
Loading...
Need help?
General
