MSM466-R Outdoor 802.11n
Access Point Quick Start
Guide
Abstract
The MSM466-R 802.11n dual-radio Access Point [J9715A
(Americas), J9716A (Worldwide), J9717A (Japan), J9718A
(Israel)] brings 450 Mbps per radio technology to outdoor
environments for outdoor coverage, point to point and point
to multipoint applications either autonomously or centrally
controlled by MSM Controllers. This document describes
how to install and initially configure the MSM466-R,
hereafter referred to as the AP. The latest documentation is
available at www.hp.com/support/manuals.
© Copyright 2015 Hewlett-Packard Development Company, L.P.
*5998-6833*
HP Part Number: 5998-6833
Published: January 2015
Edition: 1
Hardware overview
Figure 1 AP key components (bottom view)
4. Ethernet connector1. Radio 2 antenna connectors (x3)
5. Reset button2. Vent nut (do not remove)
6. Status LEDs (Power,
nl
Ethernet, Radio 1, Radio 2)
3. Grounding lug with screw
NOTE: Three Radio 1 antenna connectors are on the
top of the AP.
Package contents
The AP, weatherproof RJ-45 Ethernet connector,
mounting bracket, 2 bracket bolts, 2 lock washers, 2
flat washers, 4 wall anchors and screws, 2 pole
clamps, and documentation.
Ethernet port
The Ethernet port is an auto-sensing 10/100/1000
Base-T (auto MDI/MDX) port with RJ-45 connector.
This port supports Power over Ethernet (PoE) 802.3af
and 802.3at (PoE+).
Antenna connectors
The AP includes no integrated antennas. It provides
three antenna connectors for each radio, color-coded
red, green, and blue. When connecting the antenna
cables, be sure to connect all three cables and to
respect the color-coding to ensure proper functionality.
See “Available antennas” (page 10).
Reset button
The reset button is on the bottom of the AP, labeled as
5 on Figure 1 (page 1). To reset the AP (same as
power cycling), press and release the reset button. To
reset the AP to factory defaults, press and hold the
reset button until the status LEDs flash three times, and
then release the button.
Page 1
To Next Page
Need help?
General
