EasyManua.ls Logo

HP MSM422 802.11n User Manual

HP MSM422 802.11n
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
HP MSM422 802.11n AP Installation Guide
Abstract
This document describes how to install and initially configure the HP MSM422 802.11n Access Point (hereafter referred to as
the AP). This document applies to these MSM422 models: J9358A/B (USA), J9359A/B (WW), J9530A/B (JP), J9617A (IL).
Professional wireless and electrical equipment experience is required. The main configuration information for autonomous
mode is found in the MSM3xx / MSM4xx APs Configuration Guide. The main configuration information for controlled mode
is found in the MSM7xx Controllers Configuration Guide.
HP Part Number:
5998-3780
Published: March 2013
Edition: 1

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the HP MSM422 802.11n and is the answer not in the manual?

HP MSM422 802.11n Specifications

General IconGeneral
BrandHP
ModelMSM422 802.11n
CategoryWireless Access Point
LanguageEnglish

Summary

Preparing for Installation (cont.)

Installation Warnings and Prerequisites

Covers important information, professional installation, and surge protection.

Installation Procedures

Wall Mounting Instructions

Step-by-step guide for wall mounting the AP.

Suspended Ceiling Mounting

Instructions for mounting the AP on a suspended ceiling.

Installation Procedures (cont.)

Initial Configuration (Autonomous Mode)

Autonomous Mode Initial Setup Overview

Procedure for initial setup and configuration in autonomous mode.

Initial Configuration (Autonomous Mode) (cont.)

Computer Configuration for Setup

How to configure the computer for initial AP setup.

Assigning an IP Address to the AP

Methods for assigning an IP address to the AP.

Cable Connections and Power-On

Instructions for connecting cables and powering the AP.

Testing the Wireless Network

Procedure to verify the wireless network functionality.

Switching to Autonomous Mode

Steps to change the AP's operating mode to autonomous.

Logging into the Management Tool

How to access and log into the AP's web-based management tool.

Basic Wireless Protection Setup

Steps to configure basic wireless security (WPA).

Regulatory Information

US FCC Compliance and Notices

Details US FCC compliance, Class B statement, and notices.

Regulatory Information (cont.)

Related product manuals