EasyManua.ls Logo

HP Notebook PC - Removing Automatic Drivelock Protection; Using Computer Setup Security Features; Securing System Devices

HP Notebook PC
138 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Removing Automatic DriveLock protection
To remove DriveLock protection in Computer Setup, follow these steps:
1. Turn on or restart the computer, and then press esc while the “Press the ESC key for Startup Menu”
message is displayed at the bottom of the screen.
2. Press f10 to enter BIOS Setup.
3. Use a pointing device or the arrow keys to select Security > Automatic DriveLock, and then press
enter.
4. Use a pointing device or the arrow keys to select an internal hard drive, and then press enter.
5. Use a pointing device or the arrow keys to select Disable protection.
6. To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of the
screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select File > Save Changes and Exit, and then press enter.
Using Computer Setup security features
Securing system devices
You can disable or enable system devices from the following menus in Computer Setup:
Boot Options
Device Configurations
Built-In Device Options
Port Options
To disable or reenable system devices in Computer Setup, follow these steps:
1. Turn on or restart the computer, and then press esc while the “Press the ESC key for Startup Menu”
message is displayed at the bottom of the screen.
2. Press f10 to enter BIOS Setup.
3. Use a pointing device or the arrow keys to select System Configuration > Boot Options, or
System Configuration > Device Configurations, or System Configuration > Built-In Device
Options, or System Configuration > Port Options.
4. Press enter.
5. To disable an option, use a pointing device to clear the checkbox next to the option.
– or –
Use the arrow keys to select the option, and then press enter.
6. To reenable an option, use a pointing device to check the box next to the option.
– or –
Use the arrow keys to select the option, and then press enter.
7. To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of the
screen, and then follow the on-screen instructions.
90 Chapter 10 Security

Table of Contents

Related product manuals