HP Officejet 100 - Installing and Using the Printer Battery

Load transparencies
To load transparencies
Use these instructions to load transparencies.
1. Lift the input tray.
2. Slide the paper width guide out as far as possible.
NOTE: If you are loading larger-sized media, pull the input tray to extend it.
3. Insert the transparencies rough-side or print-side up and align them squarely
against the paper guide. Make sure the adhesive strip is pointing down.
NOTE: Do not load paper while the printer is printing.
4. Adjust the transparencies width guide so it fits snugly against the sides of the
transparencies.
Load custom-size media
To load cards and photo paper
Use these instructions to load custom-size media.
CAUTION: Use only custom-size media that is supported by the printer. For more
information, see
Media specifications.
1. Lift the input tray.
2. Slide the paper width guide out as far as possible.
NOTE: If you are loading larger-sized media, pull the input tray to extend it.
3. Insert the media print-side up and align it squarely against the paper guide.
NOTE: Do not load paper while the printer is printing.
4. Adjust the paper width guide so it fits snugly against the sides of the paper.
Install and use the battery
The lithium-ion rechargeable battery comes with the HP Officejet 100 Mobile Printer in
some countries/regions and is available for purchase as an optional accessory in other
countries/regions. For more information, see
HP supplies and accessories.
This section contains the following topics:
•
Battery safety
•
Understand the battery
•
Charge and use the battery
Install and use the battery
17