Tray 3 interconnect PCA
1. Remove the rear cover. See Rear cover on page 23.
2. Remove the FFC (callout 1) from the tray 3 interconnect PCA.
Figure 1-199 Remove the Tray 3 interconnect PCA (1 of 2)
1
3. Use a small screwdriver to release the tab on the right side of the PCA (callout 1), and lift the PCA
slightly. Release the tab on the left side of the PCA (callout 2), and then remove the PCA.
Figure 1-200 Remove the Tray 3 interconnect PCA (2 of 2)
12
134 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
