Pick encoder distribution PCA
1. Remove the main PCA. See Main PCA on page 126.
2. Disconnect two cables (callout 1).
Figure 1-201 Remove the pick encoder distribution PCA (1 of 2)
1
3. Remove one screw (callout 1), which requires the T10 Torx driver with the 25 mm (1 in) shaft.
Figure 1-202 Remove the pick encoder distribution PCA (2 of 2)
1
4. Remove the PCA.
Reinstallation tip Make sure that the encoder disk is seated correctly in the sensor when
reinstalling the PCA.
ENWW
Removal and replacement procedures
135
To Next Page
Loading...
