3. Loosen the two screws at the bottom that secure the back cover to the computer. Keep turning the
screwdriver until you hear five clicks. These clicks indicate that the screw is sufficiently loosened.
Do not attempt to remove the screw from the hole. If present, loosen the screw (1) at the center of
the back cover.
4. To remove the back cover from the computer, start lifting from the lower left corner.
NOTE: You might have to exert force to remove the back cover from the computer. There might
be a cracking sound as the back cover separates from the computer. The sound occurs when the
latch hooks on the back cover slide off the latch bases on the computer.
4 Chapter 1 Preparing the computer for wall-mounting
To Next Page
Loading...
Need help?
General
