Curl or wave
●
Check the media type and quality. Both high temperature
and humidity cause media to curl.
●
The media might have been in the input tray too long.
Turn over the stack of media in the tray. Also, try rotating
the media 180° in the input tray.
●
The fuser temperature might be too high. In your printer
driver, make sure the appropriate media type is selected.
If the problem persists, select a media type that uses a
lower fuser temperature, such as transparencies or light
media.
Wrinkles or creases
●
Make sure that media is loaded properly.
●
Check the media type and quality.
●
Turn over the stack of media in the tray. Also, try rotating
the media 180° in the input tray.
●
For envelopes, this can be caused by air pockets inside
the envelope. Remove the envelope, flatten the
envelope, and try printing again.
Toner-scatter outline
●
If large amounts of toner have scattered around the
characters, the media might be resisting the toner. (A
small amount of toner scatter is normal for laser printing.)
Try a different media type.
●
Turn over the stack of media in the tray.
●
Use media designed for laser printers.
ENWW Improve print quality 79
To Next Page
Loading...