8. Coat the new/cleaned wiper blade with your preferred
lubricant. Install the wiper blade and two screws.
9. Install the cleaned PCR. Place a small amount of conductive
grease on to the black holder side of the shaft. Just a small
amount of grease is more than sufficient.
10. Place another small amount of conductive grease on to
the metal drum axle.
11. Install the new/cleaned drum hub side first.
Place the waste/drum section aside.
UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE TONER CARTRIDGEUNINET IMAGING INC. • BROTHER 1240/1650 • DISASSEMBLING THE TONER CARTRIDGE
HP P1006 SERIES • CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
To Next Page
Loading...
