Reinstallation notes for the gear assembly
Reinstallation tip Close the cartridge door and press the large gear against the device chassis
before you start to reinstall the gear assembly.
Reinstallation tip The spring (callout 4) has a "locating pin" that should be inserted into the
small hole in the gear-assembly plate before reinstallation.
Reinstallation tip Use the rod (callout 5) on the gear-assembly plate as a locator to find the
correct positioning of the gear assembly. Insert the rod into the hole in the lower gear on the
device chassis.
5
4
Figure 5-43 Reinstalling the gear assembly
110 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...