Tray 1 solenoid
1. Remove the following components:
●
Control panel (see
Control panel on page 78)
●
Fan assembly (see
Figure 5-21 Removing the ECU (1 of 8) on page 88)
2. Remove one screw (callout 1), and then disconnect and unroute the solenoid cable (callout 2) from
the ECU.
1
2
Figure 5-44 Removing the tray 1 solenoid
3. Lift the solenoid off of the device chassis.
ENWW Tray 1 solenoid 111
To Next Page
Loading...