Need help?Do you have a question about the HP Pavilion d4000 - Desktop PC and is the answer not in the manual?
General| RAM | Up to 2 GB DDR SDRAM |
|---|---|
| Chipset | Intel 865G |
| Network | Integrated 10/100 Ethernet |
| Processor | Intel Pentium 4 |
| Graphics | Integrated Intel Extreme Graphics 2 |
| Operating System | Windows XP Home/Professional |
| Optical Drive | CD-ROM, CD-RW, or DVD-ROM |
| Ports | USB 2.0, serial, parallel, audio in/out |
| Expansion Slots | PCI slots |
| Audio | Integrated sound card |
Prepare the PC for safe handling and component servicing. Read safety and terminology guidelines.
Remove media, shut down the PC, disconnect cables, and allow components to cool.
Reconnect power and peripherals, then power on the PC. Install drivers if needed.
Loosen securing thumbscrews and pull the panel handle to detach the side panel.
Align panel hooks, slide forward into place, and tighten thumbscrews.
Press tabs inside the chassis, pull the handle to free the panel, and lift it off.
Align front panel with chassis slots and press into place until latched.
Identify bays for optical drives, diskette drives, memory card readers, and hard disk drives.
Prepare PC, remove panels, disconnect cables, and release drive from chassis.
Remove blank plates/shields, align guide screws, slide drive into bay, and connect cables.
Locate HDD, disconnect cables, release drive from cage by lifting latch and sliding.
Remove old drive, ensure jumper settings, install guide screws, slide new drive into cage.
Prepare PC, remove panel, locate slots, release latch/screw, rock card out, store safely.
Align card with slot, press down firmly, secure with latch/screw, replace panel.
To Next Page
