Power cable
Description Spare part number
The power cable is included in the Cable Kit 626734-001
Before removing the power cable:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
Battery on page 34)
b. Hard drive (see
Hard drive on page 36)
c. Keyboard (see
Keyboard on page 42)
d. Top cover (see
Top cover on page 45)
Remove the power cable:
1. Position the base enclosure with the front edge towards you.
2. Lift up on the power cable (1) and disconnect the cable from its routing (2) to remove the power
cable.
Reverse this procedure to install the power cable.
54 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General