9. Insert a memory module in the primary memory module slot:
a. Align the notched edge (1) of the memory module with the tab in the memory module slot.
CAUTION: To prevent damage to the memory module, hold the memory module by the
edges only. Do not touch the components on the memory module, and do not bend the
memory module.
b. With the memory module at a 45-degree angle from the surface of the memory module
compartment, press the module (2) into the memory module slot until it is seated.
c. Gently press the memory module (3) down, applying pressure to both the left and right edges
of the memory module, until the retention clips snap into place.
10. Align the tabs (1) on the memory/wireless module compartment cover with the notches on the
computer.
NOTE: If you removed a memory module from the expansion memory slot before removing the
primary memory module, replace the memory module in the expansion memory module slot.
11. Close the cover (2).
80 Chapter 9 Memory modules
To Next Page
Loading...
Need help?
General