B1
HP All-in-One • 9
a Remove the yellow plug from the back of the device.
b Connect one end of the Ethernet cable to the Ethernet
port on the back of the device.
c Connect the other end of the Ethernet cable to the hub/
router/switch. If the cable is not long enough, you can
purchase a longer cable.
Important: Do not connect the Ethernet cable to a
cable modem.
You must have a working network. If you already
connected the USB cable, do not connect the Ethernet
cable.
Section B: Ethernet (wired) network
Connect the Ethernet cable
a
c
b
To Next Page
Loading...