HP Photosmart 2710

1
Get started
This guide complements the information in the printed Setup Guide and the User Guide
that came with your HP all-in-one. It describes how to set up your HP all-in-one in a
network, which includes configuring and connecting the device, and installing the
software. This guide also provides examples of recommended networks, network
management information, and troubleshooting tips.
Connecting your HP all-in-one to a network enables you to share your HP all-in-one and
all of its capabilities with every computer on the network. However, if you do not intend
to connect to a network and want a direct USB connection instead, please see the
Setup Guide for information.
Use this chapter to help you find information on the following topics:
● Choose a network type
● Choose a connection type
● Use the network management tools
● Switch from a USB connection to a network connection
● Connect additional computers
● Get HP support
Note For definitions of terms used in this guide, see the Glossary.
Choose a network type
The kind of network you have, or the one you plan to set up, will determine how you
connect your HP all-in-one to the network. If you already have a functioning network,
and you know the kind of connection you want to use, you can go on to the next section
and choose a connection type. However, for ideas on setting up your network, please
see Choose a recommended wireless network and Choose a recommended Ethernet
network.
Choose a connection type
There are two types of wireless network connections and one Ethernet (wired) network
connection that you can use for your HP all-in-one. Each of these is described briefly
below.
Wireless connection with an access point (infrastructure)
An infrastructure wireless network uses an access point (also known as a wireless
router) that provides a secure and flexible connection for your HP all-in-one. For
information, see Connect to a wireless network with an access point.
HP all-in-one Network Guide 3