HP PhotoSmart 945 - Image Transfer and Display Options; Unloading Images to a Computer

Chapter 5: Unloading, Printing, and Displaying Images 77
Chapter 5:
Unloading, Printing, and
Displaying Images
Unloading Images to a
Computer
NOTE You can also use the optional HP 8881 camera dock to
do this task. See Appendix B: Camera Dock on
page 129.
1 Confirm the following:
•
The HP Photo & Imaging software is installed on your computer
(see Installing the Software on page 20).
• If you are using a Macintosh computer, the camera’s
USB Configuration is set to Disk Drive in the Setup menu
(see USB Configuration on page 88.)
2 Turn off the camera.
3 Your camera came with a
special USB cable for
connecting the camera to a
computer. Connect the larger
end of that USB cable to the
computer.
4 Open the rubber door on the
side of the camera and
connect the small end of the
USB cable to the USB
connector on the camera.
MF