13. Flex the top (4) of the bezel, the inside edges of the left and right sides (5), and then the bottom
(6) of the bezel until it disengages from the display enclosure.
14. Remove the display bezel (7).
The bezel is available using spare part number 731994-001.
Screw covers are available in the Rubber/Plastics Kit, spare part number 727762-001.
15. If it is necessary to replace the webcam module from the display enclosure, remove the tape from
atop the module (1), disconnect the cable from the module (2), and then gently pull the module
away from the double-sided tape on the display enclosure (3).
The webcam module is available using spare part number 721543-001.
Component replacement procedures
67
To Next Page
Loading...
