16. If you need to remove the display panel, remove the 6 Phillips PM1.5×3.0 screws (1) that secure
the display panel to the display enclosure, and then rotate the top of the panel up to remove it (2).
17. If you need to remove the display panel/webcam cable, disconnect the cable by lifting the tape
(1) that covers the connector, lifting the cable lock (2), and then disconnecting the cable from the
panel (3).
18. Remove the display/webcam cable from the back of the display panel.
The display/webcam cable is available in the Cable Kit, spare part number 727757-001.
68 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
