To Next Page

To Previous Page

5–2 Maintenance and Service Guide

Computer Setup

To exit Computer Setup, use one of the following methods:

■ To exit Computer Setup without saving your changes, click the Exit icon in the lower-left corner of the screen,

and then follow the on-screen instructions.

– or –

Use the

tab key and the arrow keys to select File > Ignore changes and exit, and then press enter.

– or –

■ To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of the screen, and

then follow the on-screen instructions.

– or –

Use the

tab key and the arrow keys to select File > Save changes and exit, and then press enter.

Your changes go into effect when the computer restarts.

Restoring factory settings in Computer Setup

To return all settings in Computer Setup to the values that were set at the factory, follow these steps:

1. Turn on or restart the computer, and then press

esc while the “Press the ESC key for Startup Menu” message is

displayed at the bottom of the screen.

2. Press

f10 to enter BIOS Setup.

3. Use a pointing device or the arrow keys to select File > Restore defaults.

4. Follow the on-screen instructions.

5. To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of the screen, and

then follow the on-screen instructions.

– or –

Use the arrow keys to select File > Save changes and exit, and then press

enter.

Your changes go into effect when the computer restarts.

✎

Your password settings, language settings, security settings, and hard drive mode are not changed when you

restore the factory settings.

Other manuals for HP ProBook 4310s

Questions and Answers:

Need help?

Do you have a question about the HP ProBook 4310s and is the answer not in the manual?

General