HP ProBook 4310s - Page 74

Removal and replacement procedures
Maintenance and Service Guide 4–29
✎
When installing the display assembly, be sure to complete the following steps to properly route the
wireless antenna cables. Failure to follow these guidelines can result in degraded wireless reception.
a. Route the wireless antenna cables and microphone cable inside the clips 1 built into the top cover.
b. Align the exposed sections of the wireless antenna cables 2 with the grounding pad 3 attached to the
top cover.
c. Secure the wireless antenna cables to the grounding pad with the grounding tape 4 attached to the
top cover.
10. Disconnect the display panel cable 1 from the system board.
11. Release the display panel cable from the clip 2 that secures it.