System Configuration menu
NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
Boot Options ● Set a Startup Menu delay (in seconds).
●
Enable/disable Custom Logo (disabled by default).
●
Enable/disable Display Diagnostic URL (enabled by
default).
●
Enable/disable CD-ROM boot (enabled by default).
●
Enable/disable SD Card boot (enabled by default).
● Enable/disable floppy boot (enabled by default).
●
Enable/disable PXE Internal NIC boot (disabled by
default).
●
Set the Express Boot Popup delay in seconds.
●
Set the boot order.
Device Configurations ● Enable/disable USB legacy support (enabled by
default). When enabled, USB legacy support allows the
following:
◦ Use of a USB keyboard in Computer Setup even
when a Windows® operating system is not
running.
◦
Startup from bootable USB devices, including a
hard drive, diskette drive, or optical drive
connected by a USB port to the computer.
●
Enable/disable fan always on while connected to an AC
outlet (disabled by default).
●
Enable/disable HP QuickLook.
● Enable/disable HP QuickLook preboot authentication on
HP QuickLook boot.
●
Enable/disable HP QuickWeb.
● Enable/disable HP QuickWeb: Write Protect (disabled
by default).
● Enable/disable Virtualization Technology.
●
Enable/disable Wake on USB (disabled by default).
●
Enable/disable Numlock state at boot: Off /On (disabled
by default).
106 Chapter 5 Computer Setup
To Next Page
Loading...
Need help?
General