c. Lift the fan/heat sink from the system board (8).
NOTE: For discrete models, thoroughly clean thermal material from the surfaces of the
system board components (1)(3) and the heat sink (2)(4) each time you remove the heat
sink. All heat sink and processor spare part kits include thermal material.
UMA models:
a. To remove the UMA fan/heat sink assembly, in the order indicated on the heat sink, loosen
the 4 captive Phillips screws (1)-(4) that secure the heat sink to the system board.
b. Disconnect the fan cable from the system board (5).
Component replacement procedures
75
To Next Page
Loading...
