10. If you need to remove the display bezel, remove the 2 mylar screw covers (1) and the 2 Phillips
PM2.5×4.0 screws (2) in the bottom corners of the display bezel.
11. Flex the top (3) of the bezel, the inside edges of the left and right sides (4), and then the bottom
(5) of the bezel until it disengages from the display enclosure.
NOTE: Make sure the hinges are not bent (see hinge position in following image) when you
remove the bezel.
12. Remove the display bezel (6).
The display bezel is available using spare part number 721512-001 for all models with a
webcam and 721513-001 for models without a webcam. Display bezel mylar screw covers are
available in the Rubber Kit, spare part number 721533-001.
82 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
