HP ProBook 4425s - System Configuration Menu

System Configuration menu
NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
Boot options ● Set an f9, f10, and f12 delay when starting up.
●
Enable/disable CD-ROM boot.
●
Enable/disable floppy boot.
● Enable/disable internal network adapter boot.
●
Enable/disable MultiBoot, which sets a boot order that
can include most boot devices in the system.
● Set the Express Boot Popup delay in seconds.
●
Set the boot order.
◦
1st boot device: USB CD-ROM
◦ 2nd boot device: USB floppy
◦
3rd boot device: USB SuperDisk
◦
4th boot device: Notebook hard drive
◦ 5th boot device: USB hard disk
◦
6th boot device: Network controller
Device Configurations ● Enable/disable USB legacy support. When enabled,
USB legacy support allows the following:
◦ Use of a USB keyboard in Computer Setup even
when a your operating system is not running.
◦
Startup from bootable USB devices, including a
hard drive, diskette drive, or optical drive
connected by a USB port to the computer.
●
Enable/disable fan always on while connected to an AC
outlet.
● Enable/disable HP QuickLook.
●
Enable/disable HP QuickLook preboot authentication on
HP QuickLook boot.
● Enable/disable HP QuickWeb.
●
Enable/disable HP QuickWeb: Write Protect (disabled
by default).
●
Enable/disable Virtualization Technology.
●
Enable/disable Wake on USB (disabled by default).
● Enable/disable Wake on USB (disabled by default).
●
Enable/disable Numlock state at boot: Off /On (disabled
by default).
112 Chapter 5 Computer Setup