2. Loosen the Phillips PM2.5×10.0 captive screw (1) that secures the hard drive to the computer
and remove the two Phillips PM2.0×3.0 screws (2).
3. Grasp the Mylar tab on the hard drive and slide the hard drive (1) to the left to disconnect it from
the system board.
4. Remove the hard drive (2) from the hard drive bay.
5. If it is necessary to replace the hard drive bracket, remove the two Phillips PM3.0×3.0 hard drive
bracket screws (1) from each side of the hard drive.
62 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
