MSM3xx / MSM4xx Access Points 5.3.5 Release Notes 3 HP ProCurve Networking
Regulatory update
See also the regulatory information in the updated v5.3.5 Quickstarts available as described under
Documentation above.
REGULATORY NOTICE for European Union
As of July 1st 2010, all wireless devices sold in EU countries and any countries that participate in
the EU free market must meet stringent Dynamic Frequency Selection (DFS) requirements for
radar detection and avoidance (EN 301.893 v1.5.1). The MSM APs and the MSM7xx Controllers
used to control and configure them are compliant.
Other regulatory information
In the USA and Canada, no DFS channels are available on Radio 1 of the MSM422 even when
operating in legacy modes.
Sensors and RF Manager
Sensors (MSM320, MSM325, MSM335) at version 5.3.5 are ONLY compatible with RF Manager
version 5.9.203. If you choose not to upgrade to RF Manager 5.9.203, do not upgrade a Sensor
(directly, or via an MSM Controller) that will be used with RF Manager to version 5.3.5. See also
the MSM7xx Controllers Management and Configuration Guide.
Fixes
The following issue has been fixed since the previous release:
ID Description
42387 802.1X users may sometimes be unable to log in.
43076 (Applies to autonomous APs.) It is not possible to disable IGMP using the management
tool. The AP management tools displays a "page cannot be found" message and logs
the user out. As a work around, the following CLI command can be used to deactivate
IGMP:
no dot11 igmp snooping-helper
44396 The MSM710, MSM422, MSM335, and MSM410 may unexpectedly restart.
44894 L3 roaming may fail for wireless clients roaming between APs on different subnets and
VLANs.
44905 The CLI shows incorrect values for 802.11n multicast rate.
45142 The automatic channel selection feature may cause excessive channel switching in
environments where many APs are on the same channel.
45239 802.1X client stations are not deauthenticated if the user does not enter login
credentials within a few minutes of receiving the login prompt. This can cause client
stations to be unable to login via 802.1X.
45542 Wireless protection for a VSC should be set to WPA2 or WPA+WPA2 to ensure the best
compatibility and performance with 802.11n clients.
45806 The MSM310 and MSM320 show too many wireless FCS RX errors on Radio 1.
To Next Page
Loading...
Need help?
General
