MSM3xx / MSM4xx Access Points 5.3.5 Release Notes 5 HP ProCurve Networking
Known issues
The following known issues are present in this release:
52009 (MSM422 only.) The MSM422 Ethernet port cannot be manually set to 1000 Mbps, even
though the product supports this rate. If you set the port to Auto however, it will operate
at 1000 Mbps when connected to another device operating at the that speed.
ID Description
ID Description
33604 (Only MSM335 and MSM320/325.) The Wireless status light for a radio configured in
Sensor mode does not turn on. This is true even when the sensor is enabled and
operational.
34173 (Only MSM422.) When radio 1 is set to 802.11n (5GHz) and radio 2 is set to 802.11a,
and both are configured for local mesh, if one radio is set to a specific channel and the
other is configured for auto- channel, both radios can end up to be on the same channel.
Therefore, configure each radios for a specific (and different) channel or configure both
radios for auto-channel.
38305 (Only MSM317.) Making any configuration change on an MSM317 results in all wired
802.1X users erroneously having their connections terminated during the
synchronization process.
38621 (Only MSM317.)
Applies only when at least one non-access-controlled VSC is configured with
Ethernet Switch as the VSC ingress mapping, and one access controlled VSC is
configured with a VLAN as the VSC ingress mapping.)
This message may appear in the system log:
err confighandl Failed to read ingress VLAN information for Virtual Service
This message should be ignored.
38750 (Only MSM317.) The MSM317 may generate a CFG_SYNC_FAILURE in the log when
it synchronizes after a number of configuration changes have been made on the
controller. The MSM317 will then restart, apply all changes, and operate normally.
38984 When a third-party DHCP server is used to send alternate IP addresses for service
controller discovery using DHCP Option 43, discovery will fail if third-party options
appear in the list above the service controller IP addresses.
To avoid this problem, ensure that the service controller IP addresses option is the first
option in the list.
39804 When configuring the Allowed wireless rates option under Virtual AP in a VSC, the
user can disable support for all 802.11n data rates. If the VSC is only operating on
802.11n, then one non-MSC rate must remain operational or the VSC will not function
correctly.
39994 The Axis2 SOAP client toolkit has issues dealing with some SOAP responses.
To Next Page
Loading...
Need help?
General
