HP ProCurve 1410-24G

2-1
2
Installing the Switch
This chapter provides installation information for the 1410-8G Switch, 1410-
16G Switch, and 1410-24G Switch.
Included Parts
The switches have the following components:
■ Documentation kit
■ Four rubber feet
■ Wall/table-mount accessory kit:
■ Rack-mount accessory kit:
• Read Me First
• Switch Quick Setup Guide
• Safety and Regulatory information
• Software End User License and Hardware Warranty information
1410-8G Switch and
1410-16G Switch
1410-24G Switch
Kit number 5066-0621
Contains:
• three 3/4” (20-mm M4) screws for
wall and under-table mounting
• three wall anchors
• cable tie for power cord
Kit number 5066-0620
Contains:
• three 3/4” (20-mm M4) screws for
wall and under-table mounting
• three wall anchors
1410-16G Switch 1410-24G Switch
Kit number 5066-0622
Contains:
• two mounting brackets
• eight 8-mm M4 screws to attach the
mounting brackets to the switch
• four 5/8-inch number 12-24 screws to
attach the switch to a rack
Kit number 5066-0623
Contains:
• two mounting brackets
• eight 8-mm M4 screws to attach the
mounting brackets to the switch
• four 5/8-inch number 12-24 screws to
attach the switch to a rack