------------ ------------ -------------
Router Redundancy Using XRRP
Displaying XRRP Data
The keyword instance can be used to display configuration information for the
virtual router instance(s). If no parameters are specified after this keyword,
the information for all virtual routers is displayed, otherwise the information
for the particular virtual router is displayed by specifying the owner-router-
number and the vlan-id in the command. In the example below, the configura-
tion information for the virtual router number 1 on VLAN 5 is requested.
HPswitch(config)# show xrrp config instance 1 5
St atus and Counters - XRRP Virtual Router Configuration Information
O wner Router Number : 1
V LAN ID : 5
A uthentication Type : Simple Text Password
A uthentication Key : password
A dvertise Interval : 5
I P Address Subnet Mask
- -------------- ---------------
1 0.1.1.1 2 55.255.248.0
1 0.2.1.1 2 55.255.248.0
Figure 12-10.Example of Output for Show XRRP Config Instance [<owner-router-number> <vlan-id>]
Syntax: show xrrp statistics [global |
instance [< owner-router-num > < vlan-id >] |
router < router-num >]
This command displays XRRP status and statistics information.
If the keyword global is used, then generic information is displayed:
HPswitch(config)# show xrrp statistics global
St atus and Counters - XRRP Global Statistics Information
X RRP Enabled : Yes
T his Domain Number : 2
T his Router Number : 1
X RRP MAC Addr : 0001e 7-940601
X RRP AND Mask : fffff f-ffffff
X RRP Up Time : 46 ho urs
P kts Rx Corr upt Pkts Bad Version Bad Chksum Not Do main
- ----------- ------------
7 0 0 0 0
Figure 12-11.Example of Output for Show XRRP Statistics Global
12-19
To Next Page
Loading...
Need help?
General