1-24
Introducing the Switch
Features
Figure 1-23. Front of Module J9312A
The HP ProCurve Switch yl Module J9312A has the following features:
■ Connectivity to both copper and fiber.
■ LEDs that provide information for each port on the link status, network
activity.
■ LEDs that provide information on Module power and Module fault
conditions.
■ “hot swap transceiver” support—you can add, replace, or change the type
of any of the transceivers that you use in the SFP+ ports, without having
to first remove the module, and without having to shut down the switch.
When a SFP+ transceiver is inserted the switch authenticates it. This can
take 1-3 seconds, with the worst case being 5 seconds. If the SFP+
transceiver is removed before the authentication completes a self test
failure will be reported.
Standards adherence:
■ IEEE 802.3ae SFP+
■ IEEE 802.3ak CX4
Compliant with MSA
HP ProCurve 10-GbE yl Module with SFP+
Module Power
and Fault LEDs
Extractor Handles
Retaining screw
SFP+ ports
Link and Activity LEDs
(one pair per port)
Copper CX4 port connections
To Next Page
Loading...
