HP ProCurve 6200yl Series Advanced Traffic Management Guide

5-76
Quality of Service: Managing Bandwidth More Effectively
Advanced Classifier-Based QoS
4. (Optional) To configure a default class in a policy, enter the default-class
command at the end of a policy configuration and specify one or more
QoS actions to be executed on packets that are not matched and not
ignored.
For general information about how to configure and manage a service
policy, refer to the “Creating a Service Policy” section in the “Classifier-
Based Software Configuration” chapter.
5. Apply the QoS policy to inbound traffic on a port (interface service-policy
in command) or VLAN (vlan service-policy in command) interface.
The following restrictions apply to a QoS service policy:
■ Only one QoS policy is supported on a port or VLAN interface.
■ If you apply a QoS policy to a port or VLAN interface on which a QoS
policy is already configured, the new policy replaces the existing one.
■ A QoS policy is supported only on inbound traffic.
Because only one QoS policy is supported on a port or VLAN interface, ensure
that the policy you want to apply contains all the required classes and actions
for your configuration.
To apply a QoS policy on a port or VLAN interface, enter one of the following
commands from the global configuration context.
Context: Policy configuration
Syntax: [no] default-class action <qos-action > [action <qos-action > ...]
Configures a default class that allows one or more QoS
actions to be executed on packets that are not matched or
ignored by any of the class configurations in a QoS policy.
The default-class supports the same QoS commands as the
class < ipv4 | ipv6 > action command: rate-limit, priority, ip-
precedence, and dscp.
Context: Global configuration
Syntax: interface <port-list > service-policy <policy-name > in
Configures the specified port(s) with a QoS policy that is
applied to inbound traffic on each interface. Separate
individual port numbers in a series with a comma; for
example, a1, b4, d3. Enter a range of ports by using a dash;
for example, a1-a5. The QoS policy name you enter must be
the same as the policy name you configured with the policy
qos command in Step 2.

HP ProCurve 6200yl Series Specifications

General

Brand	HP
Model	ProCurve 6200yl Series
Category	Switch
Language	English