6-11
Stack Management for the 3500, 3500yl, 6200yl and 6600 Switches
Configuring Stack Management
Using the Menu Interface To View Stack Status
and Configure Stacking
Using the Menu Interface To View and Configure a
Commander Switch
1. Configure an IP address and subnet mask on the Commander switch.
(Refer to the Management and Configuration Guide for your switch.)
2. Display the Stacking Menu by selecting Stacking in the Main Menu.
Figure 6-5. The Default Stacking Menu
3. Display the Stack Configuration menu by pressing
[3] to select Stack
Configuration.
Figure 6-6. The Default Stack Configuration Screen
To Next Page
Loading...
Need help?
General