6-41
Stack Management for the 3500, 3500yl, 6200yl and 6600 Switches
Configuring Stack Management
Figure 6-36. Example of a Stack Showing Switch Number (SN) Assignments
To access the “North Sea” console, you would then execute the following
telnet
command:
HP Switch(config)# telnet 3
You would then see the CLI prompt for the “North Sea” switch, allowing you
to configure or monitor the switch as if you were directly connected to the
console.
HP Switch(config)# show stack view
Stack Members
SN MAC Address System Name Device Type Status
-- ------------- ------------- -------------------- ------------
0 1cc1de-cfbc80 Big_Waters-0 HP Switch Commander Up
1 000883-08f980 Big_Waters-1 HP Switch Member Up
2 000883-08f234 Big_Waters-2 HP Switch Member Up
3 0001e6-0421c0 North Sea HP Switch Member Up
The
switch
number
(SN) for
the
“North
Sea”
switch is
“3”.