2 Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
Attaching the Stand Base
1. Lift the stand base from the monitor box and set it on a flat surface such as a table top.
2. Using both hands, lift the monitor from its box, position the monitor stand over the stand base, and
press down firmly to lock it in place. Be sure the stand base is securely locked in place and adjust
the tilt angle to the desired position.
CAUTION: Do not touch the surface of the LCD panel. Pressure on the panel may cause non-
uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its
normal condition.
Figure 2-1 Attaching the Monitor Stand Base
NOTE: To remove the stand base, press inward on the tab in the center of the underside of the stand
base and pull the stand base from the stand.
Attaching the Stand Base
3
To Next Page
Loading...
Need help?
General
