NOTE:
This section lists some of the steps required to configure a Factory Integrated Model (configure-to-order or CTO server). To
ensure only valid configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales
representative for information on CTO product offerings and requirements.
NOTE:
Configure-to-order server blades must start with a CTO Blade Server.
NOTE:
FIO indicates that this option is only available as a factory installable option.
NOTE:
All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives
ordered with the server.
Step 1: Base Server Blade Configuration (Select a configurable Blade)
Models
HP ProLiant BL460c Gen8 E5-v2 10Gb FlexibleLOM Configure-to-order Blade Server
735151-B21
Configurable Models ship with:
One (1) FlexibleLOM connector providing a choice for one (1) of the supported 10Gb
FlexibleLOMs (see Step 2)
Two (2) HP small form factor hot-plug SAS/SATA/SSD hard drive bays
Two (2) x16 PCIe I/O expansion slots (one Type A, one Type A/B)
One (1) integrated USB connector and one (1) MicroSDHC connector
One (1) TPM connector
HP iLO Management Engine (standard)
HP ProLiant BL460c Gen8 10Gb FlexibleLOM Configure-to-order Blade Server
641016-B21
Configurable Models ship with:
One (1) FlexibleLOM connector providing a choice for one (1) of the supported 10Gb
FlexibleLOMs (see Step 2)
One (1) HP Smart Array P220i Controller with 512MB FBWC and RAID 0 and 1 support
Two (2) HP small form factor hot-plug SAS/SATA/SSD hard drive bays
Two (2) x16 PCIe I/O expansion slots (one Type A, one Type A/B)
One (1) integrated USB connector and one (1) MicroSDHC connector
One (1) TPM connector
HP iLO Management Engine (standard)
NOTE:
The HP ProLiant BL460c Gen8 10Gb FlexibleLOM Configure-to-order Blade
Server (641016-B21) cannot be configured the new 1866MHz HP Smart Memory or the
new 1600MHz Low Voltage (1.35v) HP Smart Memory.
NOTE:
The HP Smart Array P220i Controller FIO Kit (690164-B21) comes included with
the HP ProLiant BL460c Gen8 10Gb FlexibleLOM Configure-to-order Blade Server
(641016-B21). However, when choosing the HP ProLiant BL460c Gen8 E5-v2 10Gb
FlexibleLOM Configure-to-order Blade Server (735151-B21), the HP Smart Array P220i
Controller FIO Kit (690164-B21) must be added separately as part of the Server Blade
Configuration Process.
Step 2: Choose Required Options (one of the following from each list unless otherwise
noted)
HP Processors
NOTE:
All configure-to-order processor kits (i.e. xxxxxx-L21) contain one (1) processor.
NOTE:
If two processors are desired, select one xxxxxx-L21 here in Step 2 and one
xxxxxx-B21 in Step 4.
E5-2600 v2 series Processors
HP BL460c Gen8 Intel® Xeon® E5-2697v2 (2.7GHz/12-core/30MB/130W) FIO Processor
Kit
718045-L21
QuickSpecs
HP ProLiant BL460c Generation 8 (Gen8) Server Blade
Configuration Information - Factory Integrated Models
DA - 14208 North America — Version 31 — December 13, 2013
Page 32
To Next Page
Loading...
