Removal and replacement procedures 44
6.
Apply all the grease to the top of the processor in one of the following patterns to ensure even
distribution.
CAUTION: To avoid damage to the system board, processor socket, and screws, do not
overtighten the heatsink screws. Use the wrench supplied with the system to reduce the
possibility of overtightening the screws.
7. Align and install the heatsink. Alternate tightening the screws until the heatsink is seated properly.
8. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
33).
9. Install the hard drive backplane ("Hard drive backplane" on page 32).
10. Install the hard drives ("Hard drive" on page 26).
11. Install the hard drive blanks ("Hard drive blank" on page 26).
12. Install the access panel ("Access panel" on page 25).
13. Install the server blade.
To Next Page
Loading...
