Removal and replacement procedures 49
Item Description
3 3
rd
SAS/SATA hard drive
4 4
th
SAS/SATA hard drive
To install a hard drive:
1. Pull the hard drive shield out of the chassis.
Figure 21 Removing the hot-plug hard drive blank
IMPORTANT: Do not discard the hard drive blank. If the drive is removed in the future, you must
reinstall the hard drive blank to maintain proper system airflow.
2. Install a hard drive.
a. Push the hard drive assembly into the drive bay until it stops.
b. Press the HDD carrier latch inward until it clicks.
Figure 22 Installing the hot-plug hard drive assembly
To Next Page
Loading...
