Removal and replacement procedures 73
Power supply unit (PSU)
Located on the rear panel of the server power supply is a standard autoranging 650-watt non-hot-plug
PSU or 1200-watt hot-plug PSU with PFC (power factor correction) function.
Figure 62 Non-hot-plug power supply unit
WARNING: Take note of the following reminders to reduce the risk of personal injury from electric
shock hazards and/or damage to the equipment.
• Installation of power supply units should be referred to individuals who are qualified to service
server systems and are trained to deal with equipment capable of generating hazardous energy
levels.
• DO NOT open the power supply unit. There are no serviceable parts inside it.
To remove the power supply:
1. Loosen the screws that secure the power supply to the chassis.
2. Lift the power supply from the chassis.
To Next Page
Loading...
