Removal and replacement procedures 70
Figure 49
The top of the processor
CAUTION: To prevent overheating or a possible system crash, use only a heat sink model specified
for the HP ProLiant DL160 G6 server.
To install the heat sink:
1. Properly align the heat sink spring-loaded screws to the system board mounting holes.
2. Tighten the spring-loaded screws clockwise to secure the heat sink connection to the system
board.
Figure 50 Installing the Heat Sink Assembly
CAUTION: When installing two heat sinks, please keep the label on heat sink towards the T mark
guide orientation on the system board.
To Next Page
Loading...
